|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: ih 240 utility steers hard with lo
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Slowpoke on October 19, 2003 at 23:44:01 from (67.30.99.253):
In Reply to: Re: Re: Re: ih 240 utility steers hard with loader posted by Stan(VA). on October 19, 2003 at 06:36:40:
Thanks, Stan and K.B. Maybe someone cut a decent hole for the thru-the-hood-exhaust, then found that it was off by an inch and tore it back to fit the pipe. The broken out section was repaired using a flat plate and four long bolts held by two metal strips under the casting. Then the exhaust pipe was welded over a hole in the plate. It's amazing the way some people make poor repairs.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Stories From Old Farmer - by K. Pratt. Old Farmer, a.k.a. Dale Jensen began posting messages to our discussion forums at the grand age of 75. With extensive knowledge of farming and tractors, he valued the past and the ways that went with it. He shared these values with us until shortly before his passing. I spoke with Dale in his last days and requested his permission to share some of his stories with the readers of our magazine. He agreed, and provided the
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|