|
Farmall & IHC Tractors Discussion Board |
Re: HELP...I just got bit on a 47 A and need advic
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on October 06, 2003 at 19:12:29 from (67.1.98.107):
In Reply to: HELP...I just got bit on a 47 A and need advice... posted by Jesse on October 06, 2003 at 14:23:11:
Your block is probably plugged. It is some work but take the radiator off and then remove the bottom return on the block. Get a good lite and look in there you can take a wire and remove lots of junk and rust using compressed air and water pressure to remove the junk. There are holes between the sleeves that are probably plugged about the size of a nickle by running water in the top inlet you will be able to see if it can run out the bottom. This is hard to explain but these passages get plugged over the years and they are hard to find thru the lower part of the block. but by blowing and probing you will get water to flow thru the block and out the bottom. good luck gene b glad to help you can e-mail any time
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
