Re: yippee! pivot shaft is out! now what?

Posted by Larry in CO on September 30, 2003 at 15:59:12 from (32.97.110.142):

In Reply to: yippee! pivot shaft is out! now what? posted by bill on September 30, 2003 at 13:29:15:

Bill, You're correct that the bottom bushing will be driven out from the top. I also drove the top bushing out from the top. This caused the seal that is positioned below the top bushing to come out as well. When I put the new top bushing in, I put it in from the top as well. The hard part was getting the new grease seal in. That had to be put in from the bottom. I forget now what I used to put the seal in with, but I do know that it made it a whole lot easier to put it in while I had the bolster off and laying down. HTH. Larry

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: yippee! pivot shaft is out! now what? Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]