|
Farmall & IHC Tractors Discussion Board |
Re: 1939 FARMALL B is it worth it?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Buzzman72 on September 28, 2003 at 08:07:55 from (67.241.50.152):
In Reply to: 1939 FARMALL B is it worth it? posted by Kevin Garrison on September 27, 2003 at 17:42:50:
In the early 1980's, when my dad was still running his Farmall repair shop, a customer--actually a very distant cousin--came to us about restoring his '39 Farmall B. Since his tractor was rare for this area--single front tire/"horseshoe" instead of the 2-tire "tricycle", plus the 1/4-turn fasteners on the hood and grille rather than the usual spring latches, Dad agreed to work on it, and I agreed to help. Customer SWORE the tractor had run "6 months ago", but when we got into it, the engine was locked up tight...to the point where SOMEBODY had pulled it to try to drop the clutch and break it loose...I still have the horseshoe-shaped rod and piston hanging on the wall. And the tractor that had run "6 months ago" was missing the carb venturi, indicating that, even if it HAD run "6 months ago", it certainly hadn't run in THIS condition! So we busted our butts and made it run, and made it pretty with new paint and decals and all the right equipment, and had it ready for the Lanesville, IN show that September, as the owner had requested...and then he stiffed us on half the bill. So, on THIS one, it WASN'T worth it...but yours might be. I say GO FOR IT.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|