|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Will Wagner loader fit on IH 460 Utili
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on September 26, 2003 at 15:04:40 from (209.226.247.48):
In Reply to: Re: Re: Will Wagner loader fit on IH 460 Utility ? posted by Rich on September 26, 2003 at 05:17:19:
Rich: When you are making that much of a change, you want to get it right. No point in putting in a lot of time and expence only to have it not work. You surely must agree that a Ford 8N is a far cry in size from a IH 460 Utility. I have seen several different models of Wagner loaders. I'm not saying it can or can't be done, but you want to be doing a lot of measurments. Manuals and Spec sheets for Wagner loaders were hard enough to come by when they were new and that is close to 40 years ago. I see no solution but getting out measuring devices and calculator and drawing a few diagrams. That is what I had to do 35 years ago.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|