|
Farmall & IHC Tractors Discussion Board |
C gov. part # help
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gary_N_WV on September 10, 2003 at 05:24:28 from (129.71.234.254):
Can anyone help me with a part number?
In the governor there is a small thrust bearing.....In my I&T IH 8 manual, it is not labeled as an individual part but as an assembly (fig IH 390 # 2, Sleeve and thrust bearing) The assembly is 3 different pieces, a longer sleeve that rides against the weight assembly, the thrust bearing in the middle and then another sleeve that rides against the rockshaft lever. When I had the governor apart to start cleaning it, a couple of the ball bearings fell out of the thrust bearing........although I put them back in, I'm afraid that they will fall out later during operation and would just like to replace it.
Can anyone that has a parts manual tell me if I can get this bearing or will I have to find and buy all three parts?(I don't have a IH/Case dealer near my area to ask)
Anyone have an extra bearing they would part with?
It looks like the A,B and C series are all the same.
I have enabled my e mail address ! Thanks
Gary
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
