Farmall & IHC Tractors Discussion Board |
Re: Re: 66 int cub, carb sticking
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by souNdguy on September 06, 2003 at 21:33:21 from (12.92.12.94):
In Reply to: Re: 66 int cub, carb sticking posted by parts man on September 06, 2003 at 16:53:59:
Thanks for the info. After I wrote the mesage, I started thinking about it and figured that the governor would be the controlling body for the rpm.. not specifically the carb ( unless it was adjusted so bad.. etc ) Thanks for the idea about the throttle plate. If it does turn out to be the throttle plate.. what are my options other than a new carb. The rebuild kit I saw at TSC only had the rod the plate would attatch to.. not the plate itself... is it something that canb be repaired? like filed or honed? thanks again. Soundguy
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|