Re: Re: What should My piston rings look like

Posted by Bob Quale on September 04, 2003 at 17:41:02 from (68.63.103.222):

In Reply to: Re: What should My piston rings look like posted by EZ on September 03, 2003 at 17:37:25:

Thanks for all the replies, The cylinders are 3 3/8, so they are over bored sleves. There is no ridge at the top of the bore and the walls look good. The head gasket even lookes new. The valves have these little rubber o rings on the stems that I think are supposed to stop oil from going down the guide. They are not in the parts manual. The guids have lots of room in them. I think the bottom end and pistons and sleves were done and heads just bandaided. There is no detectable movement in the piston itself. I might take a gamble and just do the head. I must say, I usualy am not too lucky!

Thankyou for all the help, That link to rebuilds is great!!

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Re: What should My piston rings look like Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]