|
Farmall & IHC Tractors Discussion Board |
Re: how much will it pull?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ny bill o on August 22, 2003 at 18:31:14 from (69.21.49.71):
In Reply to: how much will it pull? posted by Joe on August 22, 2003 at 09:41:09:
are the back tires loaded? if not, off the top of my head, i'd say you need the extra set of rear weights, and may need to lose some of the front weights. watch what the front tires are doing when you start. if they are cutting way in, you probably could take a few (not all!) off the front without compromising safety. the 504 should handle a 10' disk ok, maybe not too fast though. if its pulling too hard, just don't let the disk cut in all the way the first time over, til the ground gets settled. the second time over, it will pull easier anyway. no need to let the jd guys have both jobs.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
More Memories of a Field Service Engineer - by Brian Dye. Introduction: The author worked for one of the largest Ford tractor dealerships in England as a trouble-shooter on tractor engines, hydraulics and combine harvesters from 1963 to 1972. In 1972 he became a dealer manager and finally left the dealer net in 1975 to run his own electronic design and manufacturing company. [Editor] We live right in the middle of Norfolk. The dealership that I worked for sold Fordson Tractors from the 1920's and some of t
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|