|
Farmall & IHC Tractors Discussion Board |
Re: Re: timing gear failure - C123 engine Farmall2
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RayP(MI) on August 14, 2003 at 05:22:37 from (216.46.197.239):
In Reply to: Re: timing gear failure - C123 engine Farmall200 posted by K.B. on August 13, 2003 at 19:50:52:
K.B. > Can't find anything that got in between the gears. Assume the damage to the distributor/governor gear caused the damage to the cam gear. No evidence of damage to hydraulic pump gear, but will take it off today and look closer. Am considering trying to repair the damaged teeth - welding and grinding/filing back to shape. Please check your book about cross fitting of other tractor engines. Believe that engine was used on a number of models in that era. Justin,> Please drop me an email at the above address. What may be harder to find than the gear, is the little ball bearings & race in the shaft that sticks into the governor off that gear!
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
