|
Farmall & IHC Tractors Discussion Board |
Re: Re: Fast Hitch #100 Balance Mower pix posted
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Evan350 on August 06, 2003 at 06:25:31 from (129.42.208.172):
In Reply to: Re: Fast Hitch #100 Balance Mower pix posted posted by Tractor Dan on August 05, 2003 at 17:01:16:
There are two sizes of 2pt fasthitch. Sounds like your mower has the smaller size prongs for the 200 series tractors, which would require a shim to fit the 350. You have some control of the guard pitch by adjusting the right chain, the higher you restrain the downward movement of the fasthitch, the guards point down more. You may have to adjust the left chain also to compensate the sickle bar lift.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
