H lift-all drive dog problem still ????

Posted by john on July 22, 2003 at 18:47:53 from (192.233.162.142):

I have posted here about my H lift-all drive dog problem before , got some good advise but I still (Think?) I have a problem. I replaced the Trans seal so I took off the drive dog on that side. I put the drive dog on hand tight with the drive dog shaft fitting snug in between the drive dogs. Start up the tractor, pull the lift-all lever (no cylinder that works) to tighten it up but it gets looser instead? To me it doesn't seem right that I can shake the drive dog shaft, I am thinking that it will wear out with the drive dogs. Should that shaft be kind of tight? Any ideas? Thanks.

Follow Ups:

• Re: H lift-all drive dog problem still ???? Aces 06:42:27 07/23/03 (0)
• Re: H lift-all drive dog problem still ???? 49 Cubber! 19:02:15 07/22/03 (1)
  • Re: Re: H lift-all drive dog problem still ???? John 18:37:36 07/23/03 (0)

Post A Followup Name: E-Mail: Subject: Re: H lift-all drive dog problem still ???? Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]