Re: Farmall 300 Hydraulics -- Quick Fix?

Posted by Bill Cole/Rochester NY on July 22, 2003 at 15:30:44 from (66.66.153.26):

In Reply to: Farmall 300 Hydraulics -- Quick Fix? posted by Rock_Picker on July 22, 2003 at 10:29:05:

The seal on my 240U was installed wrong cause
compression spring that holds ID of seal to shaft
was off. My pump is a Cessna. I ended up grinding
a chanfer on the edge of step that seal rides on
so spring wouldn't pop off. And of course seal is
pressed into ID of housing. I wet stoned where
seal rides on shaft also but if yours has a worn
groove where seal rides it will never seal. My
1hr quick fix turned into a 4hr rebuild of pump
Worked so good that had to change suction hose
cause pump vacumn collapsed it and had to lower relief valve setting.
Hope this helps BC

Follow Ups:

• Re: Re: Farmall 300 Hydraulics -- Quick Fix? Red Rider 20:10:59 07/22/03 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Farmall 300 Hydraulics -- Quick Fix? Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]