Farmall & IHC Tractors Discussion Board |
Re: Painting 856 more difficult than expected!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by here, try this on July 20, 2003 at 13:54:59 from (65.172.143.26):
In Reply to: Painting 856 more difficult than expected!! posted by IowaWill on July 20, 2003 at 07:44:59:
wait till your "helpful" friend is not around. wet sand everything, Yes, that is way too much thinner. I use aout 10% thinner. Ditch the HVLP gun, they don't have enough overspray to reach into all the little nooks and crannies. wet the floor if you need to keep down the dust or move outside where you can see. I do all my painting outside and like to spray in the morning before the wind comes up. (hopefully is is tack dry before the dust starts blowing) Painting at evening is an option but I have trouble with insects landing in the paint. When you get all done and have a nice glossy job you can thank your friend and never have to tell him what you did.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|