Farmall & IHC Tractors Discussion Board |
Re: IH Farmall Super C needs carburetor float
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Big Orn on June 18, 2003 at 14:26:46 from (63.169.152.131):
In Reply to: IH Farmall Super C needs carburetor float posted by Bruce Haverkamp on June 18, 2003 at 08:18:41:
Ditto on the JB weld. Used QuickSteel myself - same thing, just easier to apply. Couldn't find a float without buying the whole kit. I removed the float, cleaned it, sanded it, cleaned it again with carb cleaner, let it dry and smeared just a little bit of the epoxy on it (so it wouldn't weight it down too much) and reinstalled it. Works fine. Also - if you solder it - make sure it is COMPLETELY free of all gasoline or BOOM!
Follow Ups:
Home
| Forums
Today's Featured Article -
A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|