Farmall & IHC Tractors Discussion Board |
Re: Re: Re: OOPS I did it again.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kelly C on June 15, 2003 at 08:38:01 from (63.171.43.140):
In Reply to: Re: Re: OOPS I did it again. posted by disagree on June 14, 2003 at 19:36:47:
So far I really like the mower. It seems to cut real good and it follows real nice. It is also much easier to attach than the IH mower I have. That IH mower had me pulling my hair out just to find a ballance point so it wouldnt tip over wile attaching it. On the 5 just put the hydralic jack about 4 or 5 inches right of the safety release and it ballances real nice. The only other thing I noticed was after I changed the oil in the gear box. I have a leaky seal on the pitmon side.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|