Farmall & IHC Tractors Discussion Board |
Re: hydraulic problems on IH 1466
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mitchissippi on June 08, 2003 at 14:40:50 from (64.89.162.87):
In Reply to: hydraulic problems on IH 1466 posted by Ricky White on June 08, 2003 at 07:16:27:
Ricky, I had a similar problem on my 1066. Take the top link bracket off. There's a lever coming up from the torsion tube that should be in front of (toward the front of the tractor)another lever coming down from the rock-shaft housing. My lever from the bottom had gotten loose where it clamps to the torsion tube and let the lever from the top slip past it. Check and see if this is the problem. If it is, you can reach in with a piece of 1/4" rod with a "hook" bent on the end and pull back on the top lever, and the lift will go down. BE CAREFUL! Make sure the lift arms don't mash you when they fall! Hope this helps, Mitch
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|