Farmall & IHC Tractors Discussion Board |
Re: Replacing Water Pump on '49 H, what parts need
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RC on June 02, 2003 at 06:25:37 from (64.12.97.13):
In Reply to: Replacing Water Pump on '49 H, what parts needed? posted by Brent on June 02, 2003 at 05:30:07:
Sounds like you have everything you will need to replace your water pump. I used RTV sealant and gaskets when I rebuilt the water pump on my '46 H. I also used a little RTV sealant on the hose outlets before tightening the hose clamps on the hose ends. Be sure you take the packing nut off the front end of the water pump and check to see there is packing behind it. If there is not enough you will need to get some. The packing can be obtained from any IH/Case dealer and is part# 45925DA.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|