|
Farmall & IHC Tractors Discussion Board |
Re: Re: C runs Poorly
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Carm on June 01, 2003 at 17:41:42 from (32.101.61.227):
In Reply to: Re: C runs Poorly posted by Tractor Dan on June 01, 2003 at 14:19:42:
I put in new plugs and gapped them. Old ones were black sooty. No evidence of oil contamination...good thing. It runs a little better now. BUT Not quite right. It seems that if I pul;l the choke out a little bit I gan get it to run better so it does not really stumble when it accelerates. It has a zenith carb which i just took off and cleaned. Cannot see any obvious intake leaks and there is no black smoke to indicate over rich mixture. Im getting closer but not there yet!
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|