Re: shimming belt pulley pto on an (A)

Posted by Hugh MacKay on May 31, 2003 at 18:49:20 from (209.226.106.45):

In Reply to: shimming belt pulley pto on an (A) posted by JONATHAN MIRGON on May 31, 2003 at 15:04:34:

Jonathan: When you refer to book which book are you using? I have an IT manual and yes I agree it is quite vague also. It shows shims at hub of the pulley it refers to as Y and the shims where gear box mounts it refers to X Here is all they say," Vary the number of shims (X and Y) so that heels of gears are in register and backlash is 0.004-0.006 "( IT recommended) My opinion quite lazy writing. Just where you measure this backlash I'm not quite sure. I trust you can see enough through the top plug to tell if the heel of those gears are in register.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: shimming belt pulley pto on an (A) Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]