Farmall & IHC Tractors Discussion Board |
Re: Using PTO for first time
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Shawn on May 24, 2003 at 16:11:25 from (205.188.209.140):
In Reply to: Using PTO for first time posted by Sean in Calgary on May 23, 2003 at 10:15:17:
Listen well to the other post. Your ears will be the key, nothing may show visibly. Hook to your implement, if it is a pull piece not 3pt, be straight inline. Then engage PTO at lower RPM & listen for sounds in the rear end housing, if no grinding or clunking is heard, slowly increase RPM to max throttle, listen for noises as you do so. If you hear no noise then field test implement. As before start at lower RPM & increase. (Note) most implements can not be loaded at idle, or engine will stall, start at 1/2 throttle & work up while listening.
Follow Ups:
Home
| Forums
Today's Featured Article -
A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|