|
Farmall & IHC Tractors Discussion Board |
Re: 1206 Hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Aces on May 19, 2003 at 15:49:36 from (205.187.80.142):
In Reply to: 1206 Hydraulics posted by JEFF FISHER on May 19, 2003 at 15:22:04:
There is no adjustments depending which dydraulic system your talking about as to where you can connect. If the hitch and remote that pump under the left brake as a port in the pump mount block or just plug into a remote valve the relief valve is in the right hand seat suport if bad get new relief valve and replace. If the power steeling and TA pump behind the MCV vlve on left side of TA there is a port in the MCV valve to connect to. The relief valve is in the MSV housing need new spring and valve.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Step by Step Carburetor Overhaul - 1952 Ford 8N - by Don Stewart. The carburetor kit for the TSX-241A/B/C carburetor is being supplied in only one flavor nowadays. It includes a replacement throttle shaft, new butterfly valve screws, fuel inlet filter, new float needle and seat, new float pin and
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|