Farmall & IHC Tractors Discussion Board |
Re: Re: Farmall Super A Steering Repair
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by AlBie on May 17, 2003 at 02:13:00 from (63.234.28.26):
In Reply to: Re: Farmall Super A Steering Repair posted by scotty on May 16, 2003 at 06:42:54:
Just went throgh this repair because they bent the seal and it was not leaking as it held no oil. BUT it was serviced with the same steering arm on both sides and my repair manual calls for a different number for each side. Looking for the right side steeing arm for a Super A I or may have to cut a new keyway on the wrong steering arm. Albie
Follow Ups:
Home
| Forums
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|