Re: Super A Points- How do I install properly

Posted by Hugh MacKay on May 05, 2003 at 04:08:28 from (216.208.58.163):

In Reply to: Super A Points- How do I install properly posted by PGNS on May 05, 2003 at 03:09:21:

The points and condencer are quite easy. Just look it over quite well before you start, to insure you get it back right. Your gap is set by the L shaped terminal, it has a slot behind the screw. Setting should be .020 inch when the other half is on high point of cam lobe. Be careful on the wire from condencer, just be sure clip on end of wire is not making contact with distributor housing. That little nut that holds point spring and condencer wire is an oddball size. I bought a half dozen different wrenches. Finally I took a file to one of my 5/16 wrenches. It has to be 11/32 as 3/8 is too large.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Super A Points- How do I install properly Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]