Farmall & IHC Tractors Discussion Board |
Re: equipment to fit a C Farmall
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve Mason on April 24, 2003 at 13:50:09 from (207.177.31.118):
In Reply to: equipment to fit a C Farmall posted by Matthew Webb on April 22, 2003 at 14:03:16:
I think the best thing you can do is put a 3 point hitch on it. Then you can use just about any implement you want. I think it may be tough to find implements that were built for the C's originally. I am in process of trying to figure out a way to build a 3 point for my C. There are kits you can buy, one is from Saginaw and it is sweet because it has its own hyd cylinder, however, with shipping I'm looking at $700. I also looked at a Worksaver kit (works off the C touch control hydraulics) and my local dealer wants $700 for that. Too much money for my wallet. Anybody got any hints or tips on making a 3 point for a C?
Follow Ups:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|