Farmall & IHC Tractors Discussion Board |
BN oil issues
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by mk on April 23, 2003 at 16:42:01 from (66.186.175.165):
I was out plowing with my BN today and noticed I have a leak around the front main seal. It isnt' a big one, I did all my work and didn't have to add any oil. I'm guessing it lost a couple spoon fulls over the 2 hours of work. So my first question is how hard is it to replace the seal? I've seen a few posts on replacing them on Cs, but not B/BNs. Is just a matter of pulling the cover and the crank pully? Next question, since I saw the leak I keep an eye on my oil pressure (not that the two would really be related, but you know when one thing goes wrong...) and noticed that it's on the low side. The tractor runs like a top, doesn't burn any oil etc so I hate to have to open it up and start replacing bearing. The other thing that caught me as odd is that the gauge is half full of oil, so I wonder if it isn't just the gauge. What do you guys think? Thanks mk BTW, some one wanted pictures of BN-187 plow all hooked up. I'll get the digital camera out tomorrow and post a few. I have to admit that plowing is pretty enjoyable (we are tiller people for the most part).
Follow Ups:
Home
| Forums
Today's Featured Article -
Oliver 550 Purchaser Checklist - by Greg Sheppard. Pound for pound the 550 is better than anything I've seen. It has great power for its size and can really hunker down and lug. Classified as a 3-bottom plow depending on soil conditions. I personally don't think it can be beat for a utility tractor in the 40 HP range. They are extremely thrifty on fuel, at least my DSL is. Most drive train parts are fairly easy to get. Sheet metal is probably the hardest thing to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|