Farmall & IHC Tractors Discussion Board |
Re: Painting Help
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Roger on April 19, 2003 at 19:35:15 from (198.31.223.135):
In Reply to: Painting Help posted by Peabody on April 18, 2003 at 20:03:32:
I have also used the IH 2150 with good results. I really like the HVLP sprayer I bought and have used on the last two tractors. Only had one small run on the last tractor paint job. The big problem painting tractors is all the irregular surfaces. As someone said, you need to start with the inner surfaces and work out. Also, what I find works is to use spay cans to get into areas you can't get to with your spray gun as you can buy the 2150 paint in cans. Weeks and months after I get my tractor painted I find spots that have a thin coat. You need to look over the tractor real well after you are done to make sure it is all covered. That is where I get the spray cans out and touch up the thin area. Roger
Follow Ups:
Home
| Forums
Today's Featured Article -
A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|