Re: Re: Super C project

Posted by Bill B on April 18, 2003 at 07:22:17 from (68.118.183.168):

In Reply to: Re: Super C project posted by Kelly C on April 17, 2003 at 06:15:50:

I am using PPG omni paint with hardener. No thinner added. I use a cheap ($125) HVLP gun, and use a bit more pressure than they advise. Very little overspray, uses less paint, easier to see and better for the breathing (use a good respirator). Those parts came with tisco paint on them, and they were not at all shiny, and had been done at a body shop. Cheap paint=cheap results. This omni paint is about 1/4 the price of the good PPG concept paint that I did my F20N with, and the results are pretty much as good, certainly good enough for a tractor. It cost about $100 for a gallon of IH red and a quart of hardener. Dont think you can use the cheap $40 a gallon enamal and get the same results.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Re: Super C project Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]