Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Offset Farmalls wiring harness
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on April 13, 2003 at 03:16:48 from (216.208.58.168):
In Reply to: Re: Re: Re: Offset Farmalls wiring harness posted by Glenn(WV) on April 12, 2003 at 19:24:11:
Glenn: The other idea that was tossed out by a couple of people is wire is for use with mag if so equiped. Any diagrams on wiring I seen show wire to mag going along right side of tractor. Secondly, it would not need a 10 or 12 gauge wire to mag. and I rather doubt that by the time 140 came out that anyone was too worried about wires to the mag. I doubt that any were ever built with mag. ign. If this wire was not on SA, 100 and 130, it must have been added to 140 for a new attachment. Horn is best that I have heard.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|