Farmall & IHC Tractors Discussion Board |
C20 High Speed Plow
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BobG in VA on March 25, 2003 at 16:40:28 from (152.163.189.203):
Have had an IH sickle bar mower and C20 (2 bottom with coulters/tailwheel (both are FastHitch) at my folks home place for about 6 weeks. Problem is my 230 is about 120 miles away with me. I went down today and picked up the plow and brought it back today. (For Stan (VA): Came by Morrisville this afternoon and wish I knew where you lived). Plow has both coulters and tailwheel and is the Special High Speed slatted moldboard. I don't think it has been used in 20+ years but everything is there and the points are good. Pumped it full of grease and the coulters spun beautifully! Can't wait to back up the 230 to it this weekend (assuming I don't have to hang shades for the better half). Thanks for letting me share.... BobG in VA
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|