Farmall & IHC Tractors Discussion Board |
Re: Hammer mill Farmall H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on March 20, 2003 at 19:28:48 from (63.147.130.146):
In Reply to: Hammer mill Farmall H posted by Scott in MO on March 17, 2003 at 19:49:33:
As mentioned below, putting one twist in the belt will change the direction of pulley travel on what you are belting up to. Putting 2 twists will be the same travel as not having any twists. I have an all iron pulley for my H (not a compressed paper pulley like you commonly see). My all iron pulley is slightly larger in diameter size then the paper pulleys. I was told that it was for running a hammer mill. It is just guessing 2 to 4 inches larger in diameter. Never run a hammer mill with it so I don't know if the oversized pulley is nescisary.
Follow Ups:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|