|
Farmall & IHC Tractors Discussion Board |
230 RUNS!!!!!!!!!!!!!!!!!!!!!!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave M on March 19, 2003 at 05:19:48 from (170.158.254.158):
Last year my Justin and I dragged a 1957 230 out of a neigbors hedgerow, so we could try to get it running for him, For starters the engine was stuck from sitting for two years, so out came the penetrating oil, it freed up, easily, then we rewired it, got the starter, generator, and voltage regulator, rebuilt, cleaned the carb, new plugs, wires, cap, rotor. When we darined the oil about a galllon of water came out because the oil fill cap was off, after putting new oil in, and fresh gas we rolled it out of the barn, stuck the booster pack on it and gave it a shot of ether, and it started, it runs good, it smoked for a feww minuted till the oil we had out in the cylnders burn off, then it clearded up and ran great, Dave m
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|