Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: 3-pt hitch for a Farmall M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve - IN on March 02, 2003 at 11:25:10 from (12.222.18.37):
In Reply to: Re: Re: Re: 3-pt hitch for a Farmall M posted by Hugh MacKay on March 02, 2003 at 08:02:31:
Hugh, I don't think many of use our aftermarket 3pts. for plowing. If we did, draft control would be a big item on the wish list; like you say. My semi-new tractor, a 36 yr old JD1020 row crop utility has a factory 3pt, but no draft control. Like you say, it's a hassle even pulling my 2 bottom Dearborn; I become the draft control with my hand always on the hydraulic lever. The easier way is to take something like a M with an aftermarket 3 pt and put something like my little Dearborn on it. Not real efficient, but the big ol' guys don't seem to notice the lack of draft control even in our Indiana clay, they just keep on goin'. Steve
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|