Farmall & IHC Tractors Discussion Board |
Re: Re: Farmall A engine ID, electrics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ted on February 25, 2003 at 02:11:27 from (216.158.64.43):
In Reply to: Re: Farmall A engine ID, electrics posted by Bob M on February 24, 2003 at 17:34:49:
Thanks to all for the replies and warm welcome! Bob M: Without taking the switch box apart and looking, the light switch appears to have four stops by feel, but only three are used (off, dim, bright). I believe it has a voltage regulator, there is a square box mounted about two inches below the generator that has four terminals, three on one side and one on the opposite side. Yes, I would prefer to wire it in myself. I used to build and wire machine tools, so I'm good at neatly running wires from schematics and have a fair (not thorough) knowledge of electronic circuitry. Oh, yeah, about that light switch. When the front lights are dim, the rear light is bright and vice versa. Is that proper configuration? I thought it was a little peculiar. Thanks for the help! Ted
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|