|
Farmall & IHC Tractors Discussion Board |
Farmall A trany knock
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ches f/Wis on February 23, 2003 at 11:44:25 from (205.188.209.78):
This knocking sound occurs in all gears and neutral. I have replaced the spline shaft bearings and seal with a speedy sleeve.Gears are good , no missing teeth or excessive wear.The transmission rotates freely by hand with a noise every two revolutions of the spline shaft. the knock stops when the clutch is used. I've replaced the cover/shift forks assembly with one from a tractor without a knock. (no help) The transmission shifts normaly.The noise seems to be louder near the oil slinger gear. The oil slinger rotates at 1/2 the speed of the spline shaft, this could be the reason for the frequency of the knock. Could this be the reason for the knock? Can you test or inspect this gear without dissasembling the trany and differential? After spliting this tractor three times I'm getting good at it,I wish it was as easy to get it back together.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Horsepower Defined - by Staff. Indicated Horsepower This represents the power developed in the enine cylinder as obtained from the pressure in the cylinders. This is pressure obtained from an indicator which shows cylinder pressures. Indicated horsepower does not represent the actual useful power delivered by the engine. Brake Horsepower This is the actual horse power delivered by the engine to the shaft. It is equal to the "indicated horsepower" less the friction of the engine. It is useful hor
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|