Re: workmaster loader #800

Posted by Phil Auten (TX) on February 22, 2003 at 10:32:21 from (64.152.232.237):

In Reply to: workmaster loader #800 posted by C George on February 22, 2003 at 09:22:17:

I'm not familiar with that particular loader, but if the cylinder uses a packing nut on the end, try tightening it until the leak stops. If not, replace the seal, making sure the shaft isn't pitted or rusty first. If the shaft is bad you'll have to either replace the cylinder or have the shaft repaired. Like Yellot said, those two sources should pretty much cover whatever parts you might need. "Let your fingers do the walking" as the Yellow Pages commercials used to say.

Phil

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: workmaster loader #800 Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]