|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: IH300 U fast hitch float?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on February 15, 2003 at 18:54:52 from (209.226.247.60):
In Reply to: Re: Re: Re: Re: IH300 U fast hitch float? posted by RAW in IA on February 15, 2003 at 18:22:05:
I gather your 350 had the draft controlled hitch, My 560 did and it was as you say. I never plowed with my fast hitches as I used trailer plows. My 560 had a pin that you removed at bottom end of hitch lift cylinder to obtain float. The 300 did not have that pin, only way I know to obtain float was at valve. The 300-400 had a two cylinder system; cylinder at rear of tractor was lift and cylinder under brake pedals was depth controll only and not draft controll. Very early in production of 350-450 that all changed to the single cylinder at back and system had draft controll. I have heard some people say that a few of the 350-450 had same system as the 300-400. I personally have never seen one.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
