Farmall & IHC Tractors Discussion Board |
Re: super C transplant
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by SAm in NS on February 14, 2003 at 03:58:16 from (24.138.71.44):
In Reply to: super C transplant posted by gregPA on February 14, 2003 at 03:33:46:
Yes the engine should bolt in to your Super A. It is not a C-113 but the C-123. It uses the same block but with thinner sleeves (to get an 1/8" bore increase) and a few more rpm. The problem is that the Super C had a radiator that was 2" taller (the grill was lenthened, and the hood and gas tank were raised to match) and it also used a water pump. You may be able to get away with just adding a water pump and thermostat to your current system depending on how hard you work the tractor. A temp. gauge might be an idea as well. I think the price might be a tad high but it depends. Hope this helps. SAm in NS
Follow Ups:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|