Farmall & IHC Tractors Discussion Board |
Re: 856 Gas any good?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by mike on February 11, 2003 at 21:45:23 from (152.163.213.54):
In Reply to: 856 Gas any good? posted by Dan on February 11, 2003 at 19:04:08:
Dan, if the gas engine is in good condition the tractors drivetrain is probably ok, as the gas engine didn't have the torque of a diesel. plus not many people can't afford to feed gas to a 95 hp tractor. be advised that per IH service bullentin, a minimum of 91 octane fuel is required. also this engine was prone to piston noise or knock. 856 is a very good model tractor, but the gas engine makes it undesireable. also it is a 30+ yr old tractor, could be good or ready for scrap. tractor should be run to temp, make sure no oil warning lights come on when idled down. there are 2, 1 in gauge cluster for engine and 1 on dash be key for trans/ta lube pres.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|