|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: IH 826 diesel smoke
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Lanny Slafka on February 09, 2003 at 20:23:58 from (65.174.55.235):
In Reply to: Re: Re: Re: IH 826 diesel smoke posted by Pete1468 on February 09, 2003 at 09:21:09:
I know the pump was checked and they told me that the injectors were rebuilt. If I take the injectors out to be tested do I need to replace the nozzle sleeves? If I need to replace them where can I get the special tool to remove and install them like they show in the manual? I started the tractor today, temp was about 62 degrees tractor turned over about seven or eight times and started start cable pulled out for starting and then held for about 45 seconds until fuel system pressured up and tractor ran fine with no problem. If I pushe the fuel start cable in then the tractor will die. After the tractor has run and I stop it it will start with about 1 turn of the motor.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
65 massey ferguson diesel
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
