Re: Clutch Allignment tool

Posted by Roger on January 27, 2003 at 19:03:02 from (198.31.223.212):

In Reply to: Clutch Allignment tool posted by Robert Laurin on January 27, 2003 at 09:51:20:

I just installed my clutch on a Farmall B without a clutch alignment tool. The way I did it was I didn't fully tighten the bolts that attach the pressure plate assy to the flywheel. I left them loose enough so that the clutch disk would slide around. When I put the tractor together I could slide the shaft in without any problems. Then I tightened the pressure plate bolts through the starter hole. It worked great. Roger

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Clutch Allignment tool Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]