Re: Clutch Allignment tool

Posted by Haas on January 27, 2003 at 12:09:43 from (166.72.245.96):

In Reply to: Clutch Allignment tool posted by Robert Laurin on January 27, 2003 at 09:51:20:

You don't need one. When you bolt the clutch up to the flywheel, get directly behind the hole in the clutch plate and sight through it. When the clutch is just tight enough so you can move the disk, line things up so you can see things are in line through the shaft hole, then tighten it on up. Never had any trouble doing it this way. Wiggle the shaft a little as you put it back together and it should slide right together.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Clutch Allignment tool Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]