|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Farmall H live hydraulics updates...
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wardner on January 25, 2003 at 14:30:41 from (65.235.132.83):
In Reply to: Re: Re: Re: Re: Farmall H live hydraulics updates... posted by Steven@nd on January 25, 2003 at 13:37:05:
I didn't know the new pumps cost $400. Didn't know they were even available. I have purchased two used M&W pumps from the YT classifieds. Both have been good. One appeared to be new. I paid around $200 for each. I have seen them go cheaper both at YT and ebay. Ya, the adapter was homemade. Made it in a Bridgeport. The only problem with this set-up is the breather has to be relocted. It is now on the valve cover like the engine in a 504. Speaking of the 504, my F504 tractor has three pumps. The third pump is off a C motor and bolts right in. Muliple pumps are handy when you want to activate more than one circuit at the same time and get full delivery from each. That extra circuit runs a clamp (similar to a thumb) on the loader bucket.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
65 Massey FERGUSON DIESEL
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
