|
Farmall & IHC Tractors Discussion Board |
Re: F20 size
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on January 24, 2003 at 20:18:09 from (63.147.130.79):
In Reply to: F20 size posted by Randy Santifer on January 24, 2003 at 19:39:27:
The standards width was fairly wide. Mine is 90 some inches wide from outside to outside of rear tires. I have the caste iron center wheel's and bolt on rims and could narrow that up a little bit. The centers are dished in but the rim is dished out. I could put the rims on dished in but don't know for sure how much more narrow that would make it. The wheels that are not caste iron center bolt on rim wheels are not adjustable so to speak. You could turn them around but probably wouldn't gain anything. Just guessing they would probably be around 90 some inches as well. They did however make a narrow guage F-20, narrower about a foot or so but just guessing. It would probably be real trailorable. The 90 some inches makes it hard to find a legal trailor to haul the F-20. A standard car trailor would be out of the question. A rubber tired F-20 is a little taller than the H. Probably in between the H and M in hieght. I have hauled my F-20 on a gooseneck flatbed trailor (trailor with bed above the trailor axle wheel's). Not sure of the legal width of a trailor like that. If I had to guess of the exact current width of my F-20 I would say like 96 or 98". Could probably narrow that up to low 90's or in the high 80's by switching my rims around since I have the adjustable wheel's.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
