|
Farmall & IHC Tractors Discussion Board |
Re: Re: 6v generator to 12v generator
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave on January 24, 2003 at 07:38:27 from (138.29.36.228):
In Reply to: Re: 6v generator to 12v generator posted by Bob M on January 23, 2003 at 19:10:31:
Bob: Good point on doubling the field current, but I have a couple engineer-to-engineer questions. First, what is the 'weak link' in the generator? I know (now) that my 6-volt gen is running double current in the field windings, but I am also running only half current in my armature (this was the reason I considered it safe and went ahead and did it). Shouldn't this help me out? I guess it would be best to run both sets of winding below their design amperage, but I was wondering how sensitive the field actually is to over-current, especially when my armature is only making one-quarter the heat than it would if run at 6 volts. Also, the exterior field windings seem more likely to shed the extra heat. I agree this is not optimal but was also wondering how different the 12-volt field windings are from the 6-volt (wire guage, number of turns, etc). Also, do you know what the typical rated field current is for these type generators? I guess I could go out and measure the ohms of the field and divide it into 6 (or 12), but that would not tell me what my field is rated to take. I guess I should be somewhat cautious since I think my generator is oiginal and the insulation isn't the greatest. But I was just wondering how cautious I should be. For the wndings, I would take it that the field would be the 'safer' of the two to run over-current (no brushes, etc.) I was just curious if you knew how much. Thanks for your insightful, technical remarks. I learned something! Dave
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Oliver 70 Row Crop - by Staff. The Oliver 70 was part of the "Fleetline Series" and was manufacturered from 1937 to 1948. The row-crop configuration could have either dual or single front wheels. The Oliver 70 was also offered in the standard, orchard and industrial configurations. The tractors were sold in Canada. An early advertisement states "Power when you want it - power when you need it - power to help put in crops when field conditions are right and time and help are limited. That's the power you'll find in an Oliv
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|