Farmall & IHC Tractors Discussion Board |
Re: dent in gas tank
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on January 21, 2003 at 07:24:40 from (216.46.130.22):
In Reply to: dent in gas tank posted by rob on January 20, 2003 at 20:11:04:
Rob, how big is the dent, I recall Dad buying an Allis C with a huge dent in the gas tank, I sanded the area to the bare metal and filled the dent with bondo, it took a lot and that dent was undetectable for the next 20 years that we owned it. Air pressure might help and you could go 40 or 50 lbs but those tanks were built of some pretty heavy stuff and I have doubts about it popping back out even with tapping on it. You will likely end up using bondo to finish up anyway.good luck from Mike in Exeter Ontario
Follow Ups:
Home
| Forums
Today's Featured Article -
A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|