Farmall & IHC Tractors Discussion Board |
Re: IH F806D
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ROB on January 20, 2003 at 09:55:03 from (205.156.215.9):
In Reply to: IH F806D posted by islerma on January 18, 2003 at 08:38:15:
It sounds like a good deal. $500.00 even if the engine is shot is pretty reasonable. You didn't say how long it has been sitting in the field. If it has had water in the engine for a winter or 2 . I would have serious doubts about the engine being salvagable. The bright side is lots of engines are available for IH tractors of that vintage. You should also look at engines out of other IH equipment. The gas engine in my 706 is out os 915 combine. I am sure the same interchanges are possible with diesels. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|