|
Farmall & IHC Tractors Discussion Board |
Re: Conversion of M Cotton Picker toHigh Cropper
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Guy Fay on January 14, 2003 at 12:17:34 from (169.207.192.112):
In Reply to: Conversion of M Cotton Picker toHigh Cropper posted by D Larson on January 14, 2003 at 11:53:16:
First, you don't get a high cropper- they're still pretty different tractors. The rear axles are different, for instance. The cotton picker tractors are designed to go from high clearence backward tractors to regular clearence forward tractors. To get them to forward, you put on the different platform and controls, and you flip the differential, as well as put on the low clearence front axle of whatever variety- I believe that front end was different too, have to look at the cotton picker parts book. Again, IH made a conversion kit to do this, and they were probably sold with the cotton pickers. Why not just leave it as is? Take the picker off if you have too, but the folks who are trying to make a high crop out of cotton picker tractors are probably screwing themselves in the long run- the cotton picker tractors are probably just as rare, if not more so. The folks who are putting on the forward operation platform, leaving the cotton picker drop axles on, and calling it a high crop, are kinda creating something that just never was run that way on a farm. I might be wrong about them never running that way on the farm, maybe someone from cotton country can chime in here. What makes a high clearance a high clearance is the chain drive drops and the high arch front axle, as well as the special hitch. Cotton pickers have the gear drive rear axles with the flange, a single front wheel (at least in the picker configuration, the other part of the year i regular clearence, they could have just about any front wheel and axle). I've been working on an article explaining the difference. Should appear soon.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
