Re: Upper Bolster Revisited

Posted by Matt K. on January 13, 2003 at 06:59:03 from (204.23.231.133):

In Reply to: Upper Bolster Revisited posted by Kelly C on January 12, 2003 at 17:28:57:

I replaced both bushings on my H ,and had to cut
the lower one with a chisel(carefully)and then
drive it out with a piece of oak,the new one
also was a very tight fit even though I had kept
it in the freezer for a day.I still have a little
vertical play in mine,I need to take it down again
and have a spacer made to shim it up,I'm not to
clear about were it should be shimmed,I think
a guy has to make sure the worm & sector gear are
riding on the center of each other.Maybe someone
has a little more info. on that?

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Upper Bolster Revisited Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]