Farmall & IHC Tractors Discussion Board |
Re: Gas or disalate Farmall H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Robert in NC on January 09, 2003 at 07:44:24 from (63.16.68.104):
In Reply to: Gas or disalate Farmall H posted by Chad on January 09, 2003 at 07:27:57:
As far as I know, IH was still offering the H-M letter series with gas/dist in 1946. I would check into seeing if the engine you have is a high compression or a low compression engine. A low compression engine would be your start on gas and switch to dist. model. A high compression engine would be your gas only model. Even if you have a low compression model engine, you can still run gas through it all day long without problems. The fuel will not bother it. The issue is going to be HP between low and high compression tractors. It all depends on what you want and if you can find what your looking for.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|